Nissan Primera

1990-1992 of release

Repair and car operation

Nissan Primera
+ Nissan Primera brand Cars
+ Current leaving and service
+ Engine
+ cooling and heating Systems
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Manual transmission, differential and main transfer
+ Automatic transmission
+ Coupling and power shafts
- Brake system
   General information
   Forward brakes
   Back brakes
   Back disk brakes
   Main brake cylinder
   Pumping of brakes
   Brake amplifier
   Adjusting valve
   Hand brake
   Adjustment of brakes
   Anti-blocking system (ABS)
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Appendices


Adjustment of brakes

Working brakes

Disk brakes on forward wheels and disk or drum-type brakes on back wheels are regulated automatically therefore no adjusting works are required. At wear of brake shoes back brakes are regulated at influence of the foot or hand brake depending on execution. A condition of it is excellent job of the mechanism of adjustment which on drum-type brakes is in a drum, and on disk brakes in a support.

The provision of an adjusting nut (shooter) on the party of the lever of the hand brake.

Adjustment of the hand brake

For adjustment of the hand brake it is necessary to regulate a nut on the party of the lever of the hand brake, in specified illustrations above a place. At adjustment act as follows:


  1. Establish a back part of the car on support and release the hand brake. For safety enclose before and behind forward wheels bricks that the car could not move down from support.
  2. Squeeze out a brake pedal more than 5 times.
  3. Cock the lever of the hand brake on 6-8 clicks and check, that back wheels were not turned. Again release the hand brake.
  4. Otherwise tighten a nut on the lever of the hand brake while back wheels will not be blocked at carrying out the above described check.
  5. Cock and weaken the hand brake and check, that both wheels rotated freely, and brake shoes did not slide on a drum. In case of disk brakes the lever of the hand brake on back supports should come back to a persistent bolt, after an otpuskaniye of the hand brake.
  6. Check, whether the control lamp of the hand brake if the lever will tighten on 1-2 click burns.
  7. Lower the car on the earth.

Elements of adjustment of height and люфта brake pedals

1 — a lock-nut, 12-15 N • m
2 — a bar of a pusher of the brake amplifier
3 — the switch of feet of signals
4 — the floor panel
5 mizolyatsiya of a floor
6 — a lock-nut, 16-22 N • m
And = люфт pedals
In = pedal height
With = a gap on the switch of stoplights
D= distance from a floor

Adjustment of a pedal of a brake

Люфт pedals of a brake it is regulated by a vvinchivaniye or a vyvinchivaniye of the switch of stoplights. At corresponding to requirements of Specifications to height of a pedal of a brake weaken a lock-nut (1) (see an illustration) and displace the switch (3) while the gap between shooters will not make 0.3 - 1.0 mm.
Take a brake pedal big and index fingers and move forward-back, resistance will not be felt yet. Notable люфт should make 1-3 mm. Otherwise execute the above described adjustment.

For adjustment of height of a pedal of a brake the pusher of the main brake cylinder (2) after weakening of a lock-nut (6) is displaced. The height of a pedal is specified in Specifications.