Nissan Primera

1990-1992 of release

Repair and car operation



Nissan Primera
+ Nissan Primera brand Cars
+ Current leaving and service
+ Engine
+ cooling and heating Systems
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Manual transmission, differential and main transfer
+ Automatic transmission
- Coupling and power shafts
   - Coupling
      General information
      Coupling check in the established condition
      Coupling removal
      Coupling repair
      Coupling installation
      Coupling adjustment
      Switching off mechanism
      Malfunctions of coupling
      The directing bearing of a shaft of coupling
      Flywheel
   + Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Appendices


3246bbf9



Switching off mechanism

 PERFORMANCE ORDER

  1. Remove the power unit and disconnect a transmission from the engine (Head the Engine) or remove a transmission (Head the Manual transmission, differential and the main transfer).
  2. Disconnect spring latches from the vyzhimny bearing of coupling on inside of a case of coupling, watch, how they are established.
  3. Remove vyzhimny the bearing.
  4. Turn a shaft of switching off of coupling while both lock pins will not occupy the situation shown on an illustration.

By means of a core (1) to beat out lock pins (2) if the shaft of switching off of coupling has to be removed.

  1. Beat out pins a suitable core.
  2. Take out a shaft of switching off and remove a fork with a returnable spring on inside.
  3. Check vyzhimny the bearing on wear or damages, holding an external holder in a hand and rotating an internal holder here and there, at the same time pressing it. Rigid places, noise or excessive люфт demand installation of the new bearing.
  4. Establish a spring on the new bearing and grease an internal groove of the bearing. Also grease places of a contact of the lever of switching off of coupling and the bearing, and also a shaft of switching off of coupling. Establish a shaft and a fork of switching off of coupling in return sequence. Fasten a spring of a shaft of switching off on inside so that both ends of a spring settled down according to an illustration above. Grease a surface of sliding of a forward cover, put on vyzhimny the bearing, and fix both spring latches.
  5. Again establish the power unit (Head the Engine) or establish a transmission if she acted in film separately.