Nissan Primera

1990-1992 of release

Repair and car operation



Nissan Primera
+ Nissan Primera brand Cars
+ Current leaving and service
+ Engine
+ cooling and heating Systems
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Manual transmission, differential and main transfer
+ Automatic transmission
- Coupling and power shafts
   - Coupling
      General information
      Coupling check in the established condition
      Coupling removal
      Coupling repair
      Coupling installation
      Coupling adjustment
      Switching off mechanism
      Malfunctions of coupling
      The directing bearing of a shaft of coupling
      Flywheel
   + Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Appendices


3246bbf9



Coupling adjustment

Coupling details

1 — a flywheel
2 — a conducted disk
3 — bolts, 22-29 N • m

4 — a coupling basket
5 — primary shaft of a transmission

Can be demanded two adjustments — adjustment of height of a pedal of coupling and adjustment люфта a coupling pedal.

Adjustment of height of a pedal of coupling

The height of a pedal of "N" (see an illustration below) should make 159.5 - 169.5 mm. For adjustment weaken a lock-nut (2) emphasis of a pedal (3) and shift an emphasis while the height will not correspond to demanded value. Tighten a lock-nut with effort of 16-22 N • m.

Elements of adjustment of a pedal of coupling

1 — the block of pedals
2 — a lock-nut
3 — a persistent bolt of a pedal
4 — a rug
5 — floor isolation
6 — a bitumen slip
7 — the floor panel
And = люфт pedals
N = pedal height

Adjustment люфта pedals

Elements for adjustment of a cable of coupling. The gap lying between shooters "And" on the lever of switching off should be regulated by means of a nut (2) after weakening of a lock-nut (1).

Люфт pedals are necessary for adjusting, if coupling is badly switched off or after installation of new details. Being guided by an illustration above:

 PERFORMANCE ORDER

  1. Weaken a lock-nut (1) and displace an adjusting nut (2) on fork inside while the gap And between shooters will not lie in limits from 2.5 to 3.5 mm.
  2. Again tighten a lock-nut (1).
  3. Several times squeeze out a pedal of coupling and check люфт once again.