Nissan Primera

1990-1992 of release

Repair and car operation

Nissan Primera
+ Nissan Primera brand Cars
+ Current leaving and service
+ Engine
+ cooling and heating Systems
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Manual transmission, differential and main transfer
- Automatic transmission
   General information
   Removal and installation
   Adjustment of an automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Appendices


Adjustment of an automatic transmission

Adjustment of the mechanism of switching

Adjustment of a cable of switching is very essential to excellent job of a transmission. When switching lever in all provisions good fixing should be felt. Otherwise or if the cable acted in film, adjustment is carried out as follows:


  1. Establish the lever of a choice of transfer to the situation "R".
  2. Connect the end of a cable of switching to the lever and tighten a cable lock-nut.
  3. Connect a switching cable to the lever shown on an illustration and screw a cable with fastening on a box.
  4. Delay a switching cable (see an illustration) to the right. It should be made by means of a dynamometer. For this purpose attach a dynamometer to the lever and pull to the right. There should be a value of 0.7 kg.

To adjustment of a cable of switching

1 — the lever of a choice of transfers on a box
2 — a fastening nut
3 — a countersupport
4 — a switching cable
  1. Move a switching cable on 1.0 mm to the left and tighten a lock-nut.
  2. Switch the lever of a choice of transfers from the situation "R" through all transfers to situation "1" to check the switching mechanism. Check, that the transmission in the situation "R" (parking) was blocked. Otherwise execute demanded adjustment by the described image.
  3. After everyone to adjustment again start the engine and switch transfers anew.
  4. In summary tighten both nuts on the cable end.

Adjustment of the switch of blocking of a starter

The switch of blocking of a starter provides engine start only in positions of the N and R lever and also serves for inclusion of lamps of a backing. For this reason this adjustment is important:


  1. Weaken bolts of fastening of the switch.
  2. Establish the switching lever in the situation "N".
  3. Insert a round core in diameter of 4.0 mm into an adjusting opening of the switch and shown on an illustration the lever is lower and again tighten bolts.

To adjustment of the switch of blocking of a starter

1 — a round core
2 — the lever of a choice of transfer
3 — adjusting openings
4 — the blocking switch