Nissan Primera

1990-1992 of release

Repair and car operation

Nissan Primera
+ Nissan Primera brand Cars
+ Current leaving and service
- Engine
   Removal and engine installation
   Engine dismantling
   Engine assembly
   Head of cylinders and drive of the gas-distributing mechanism
   Pistons and rods
   Crankshaft and crankshaft bearings
   Block of cylinders
   Compression check
   System of greasing of the engine - the general information
   Removal and installation of the pallet of a case
   Oil pump
   Check of pressure of impellent oil
+ cooling and heating Systems
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Manual transmission, differential and main transfer
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Appendices


Check of pressure of impellent oil

If there is a manometer, it is possible to check pressure of oil of the engine, if it too low. It can be learned except other on the slowed-down switching off of a control lamp of pressure of oil on the dashboard. As the engine for check of pressure of oil should be warm, at work it is necessary to be careful not to burn about hot oil or engine details. Given below value correspond to oil viscosity of SAE 20W-20 and temperature 80 ° to Page.


  1. Warm up the engine and muffle it.
  2. Disconnect a cable from the sensor of pressure of oil and unscrew the sensor.
  3. Start the engine, and let's work with various number of turns. At a good condition of system of greasing pressure of oil should have the following values (see. Specifications).

At the above described check the pallet of a case should be filled.