Nissan Primera

1990-1992 of release

Repair and car operation



Nissan Primera
+ Nissan Primera brand Cars
- Current leaving and service
   - Schedule of routine maintenance
      Introduction
      Current leaving
      General information on control
      Check of levels of liquids
      Check of a condition of tires and pressure in them
      Replacement of impellent oil and oil filter
      Check of level of liquid of system of hydrostrengthening of a wheel
      Check of level of liquid of automatic transmission
      Rotation of wheels
      Check of a condition and replacement of hoses of an impellent compartment
      Condition check, adjustment of a tension and replacement of driving belts
      Check and adjustment of turns of idling of the engine and level WITH
      Check of a condition of the battery, care of it and charging
      Check and replacement of spark plugs
      Check and replacement of candle VV of wires, covers and distributor begunka
      Check of level of oil in a manual box of gear shifting
      Check and adjustment of gaps of valves
      Check and greasing of draft of a drive of a butterfly valve
      Replacement of an element of the air filter
      Check of fuel system
      Check of functioning of system of cooling
      Check of a condition of system of production of the fulfilled gases
      Check of a condition of components of a suspension bracket and steering
      Check of a condition of protective covers of power shafts
      Check of brake system
      Check of a condition and replacement of brushes of screen wipers
      Replacement of transmission liquid
      Plums, washing and filling of system of cooling
      Replacement of the fuel filter
      Replacement of transmission oil of manual transmission
+ Engine
+ cooling and heating Systems
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Manual transmission, differential and main transfer
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Appendices


3246bbf9



Check of level of liquid of system of hydrostrengthening of a wheel

Two times year or each 10000 km of run (that will come earlier)

Periodically check liquid level in system of hydrostrengthening of a wheel in order to avoid emergence of problems with driving, such, as damage of the steering pump. Act as follows.

Do not hold a steering wheel turned against the stop in this or that party more than five seconds. It can put out of action the steering pump.

On some models the tank of system of hydrostrengthening of a wheel is located in the left part of an impellent compartment and has an unscrewing cover with built in in it measuring the shchupy. On other models the system of hydrostrengthening and the vacuum amplifier, having one general tank located in the right back corner of an impellent compartment is used.

The tank with liquid of system of hydrostrengthening of a wheel (it is specified by an arrow) is located in the left part of an impellent compartment.

 PERFORMANCE ORDER

  1. Park the car on an equal platform and cock the parking brake.
  2. On models with built in shchupy start the engine and warm up it to normal temperature. With the engine idling turn a steering wheel from an emphasis against the stop several times to remove air from steering system. Switch off the engine, uncover the tank, having turned it counter-clockwise, wipe measuring щуп dry and close a cover. Again open a cover and check liquid level. It should be between two labels.

Level of liquid of system of hydrostrengthening of a wheel should be supported between two shooters at the top ledge measuring щупа.

  1. On models with the vacuum hydraulic booster squeeze out a brake pedal ten times or until it will not start to "resist". Give a nut, uncover and make sure that level of liquid is not lower, than 6.0 mm from tank top.
  2. Add liquid small doses while it will not reach the necessary level.
Having added liquids in the tank of system of hydrostrengthening of a wheel.

Do not allow a liquid modulation. If it nevertheless happened, remove surpluses with a pure syringe. Close a cover.

  1. If it is required frequent having added liquids, check hoses and shtutserny connections of system of hydrostrengthening of a wheel on existence of signs of wear and leaks (see. Section Check of a condition and replacement of hoses of an impellent compartment).
  2. Check a condition and a tension of a driving belt (see. Section condition Check, adjustment of a tension and replacement of driving belts).