Nissan Primera

1990-1992 of release

Repair and car operation



Nissan Primera
+ Nissan Primera brand Cars
- Current leaving and service
   - Schedule of routine maintenance
      Introduction
      Current leaving
      General information on control
      Check of levels of liquids
      Check of a condition of tires and pressure in them
      Replacement of impellent oil and oil filter
      Check of level of liquid of system of hydrostrengthening of a wheel
      Check of level of liquid of automatic transmission
      Rotation of wheels
      Check of a condition and replacement of hoses of an impellent compartment
      Condition check, adjustment of a tension and replacement of driving belts
      Check and adjustment of turns of idling of the engine and level WITH
      Check of a condition of the battery, care of it and charging
      Check and replacement of spark plugs
      Check and replacement of candle VV of wires, covers and distributor begunka
      Check of level of oil in a manual box of gear shifting
      Check and adjustment of gaps of valves
      Check and greasing of draft of a drive of a butterfly valve
      Replacement of an element of the air filter
      Check of fuel system
      Check of functioning of system of cooling
      Check of a condition of system of production of the fulfilled gases
      Check of a condition of components of a suspension bracket and steering
      Check of a condition of protective covers of power shafts
      Check of brake system
      Check of a condition and replacement of brushes of screen wipers
      Replacement of transmission liquid
      Plums, washing and filling of system of cooling
      Replacement of the fuel filter
      Replacement of transmission oil of manual transmission
+ Engine
+ cooling and heating Systems
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Manual transmission, differential and main transfer
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Appendices


3246bbf9



General information on control

The term "control" is used in this Management rather for designation of a complex of procedures, than one separate procedure.

If from the moment of car purchase the schedule of routine maintenance is strictly observed, frequent checks of level of liquids and a condition, components subject to raised wear as it is offered in this Management will be carried out. The engine will long remain in a good working condition, and need for carrying out any additional work will be minimized.

Is more often, however, happens so that the engine works inefficiently owing to neglect with regular service. Even more often it happens upon purchase of the second-hand car which owners did not trouble themselves with frequent and regular checks and service. In this case, besides performance of usual procedures on routine maintenance, it will be necessary to make setup of the engine. The first step in any procedure of control or diagnostics for the purpose of improvement of operation of the engine is check of extent of compression in cylinders. Compression check (see. Head the Engine) will help to define a condition of internal components of the engine and should serve as the index at carrying out control and repair. If, for example, check of extent of compression indicates serious internal wear of the engine, usual control will not help to improve its work and will be waste of time and money. As procedure of check of extent of compression is the extremely important, the expert owning the equipment specially intended for this purpose should see off her. Engine reduction in a good working condition needs performance of the following procedures more often.

Minimum settings

  1. Check of all liquids connected with operation of the engine (The section Check of levels of liquids)
  2. Check of a condition of all hoses of an impellent compartment (Section Check of a condition and replacement of hoses of an impellent compartment)
  3. Check and adjustment of a tension of driving belts (Section condition Check, adjustment of a tension and replacement of driving belts)
  4. Cleaning, survey and check of a charge of the battery (Section Check of a condition of the battery, care of it and charging)
  5. Replacement of spark plugs (Section Check and replacement of spark plugs)
  6. Survey of VV of wires of candles, covers and distributor begunka (Section Check and replacement of candle VV of wires, covers and distributor begunka)
  7. Check of the air filter (Section Replacement of an element of the air filter)
  8. Check of system of cooling (Section Check of functioning of system of cooling)

General settings

All points of the minimum control listed above, plus.

  1. Check of system of ignition (see. Head System of electric equipment of the engine)
  2. Check of system of a charge (see. Head System of electric equipment of the engine)
  3. Check of fuel system (see. Head of the Power supply system and production of the fulfilled gases)
  4. Replacement of VV of wires of spark plugs, covers and distributor begunka (Section Check and replacement of candle VV of wires, covers and distributor begunka)