Replacement of transmission liquid
Time in two years or each 40000 km of run (that will come earlier)
Through the intervals of a time/distance in kilometers defined by Specifications replacement of transmission liquid should be made. As liquid long enough remains the hot ambassador of switching off of the engine, make this procedure only after complete cooling of the engine.
Before the beginning of work get the transmission liquid specified in the Section Types and volumes of applied greasings and liquids.
Others necessary for carrying out this procedure by tools are support for car fixing in the lifted condition, drain capacity in volume not less than 7 liters, newspapers and pure rags.
|
- To Poddomkratta the car and reliably establish it on support.
- Give a drain stopper sideways transmissions and merge liquid in pure capacity.
- Carefully clean off all metal particles from a magnet if it is available.
- Fill a transmission in the above described way. The total amount of oil filled in in a transmission makes 7.0 l, however the certain amount of oil remains in a box, it means that it is necessary to fill a transmission slowly while liquid level on a masloizmeritelny core will not correspond to demanded value.
- Lower the car and add demanded amount of liquid through a jellied mouth (see. Section Check of level of liquid of automatic transmission).
- Establish transmission in the situation "R" (Parking) and cock the parking brake, then start the engine on single turns, without squeezing out a gas pedal.
- Carry out the selector lever through all transfers and again establish it in the situation "R" (Parking). Check liquid level.
- After the several first trips check the car bottom on existence of leakages of liquid.
|
|
|