Nissan Primera

1990-1992 of release

Repair and car operation



Nissan Primera
+ Nissan Primera brand Cars
- Current leaving and service
   - Schedule of routine maintenance
      Introduction
      Current leaving
      General information on control
      Check of levels of liquids
      Check of a condition of tires and pressure in them
      Replacement of impellent oil and oil filter
      Check of level of liquid of system of hydrostrengthening of a wheel
      Check of level of liquid of automatic transmission
      Rotation of wheels
      Check of a condition and replacement of hoses of an impellent compartment
      Condition check, adjustment of a tension and replacement of driving belts
      Check and adjustment of turns of idling of the engine and level WITH
      Check of a condition of the battery, care of it and charging
      Check and replacement of spark plugs
      Check and replacement of candle VV of wires, covers and distributor begunka
      Check of level of oil in a manual box of gear shifting
      Check and adjustment of gaps of valves
      Check and greasing of draft of a drive of a butterfly valve
      Replacement of an element of the air filter
      Check of fuel system
      Check of functioning of system of cooling
      Check of a condition of system of production of the fulfilled gases
      Check of a condition of components of a suspension bracket and steering
      Check of a condition of protective covers of power shafts
      Check of brake system
      Check of a condition and replacement of brushes of screen wipers
      Replacement of transmission liquid
      Plums, washing and filling of system of cooling
      Replacement of the fuel filter
      Replacement of transmission oil of manual transmission
+ Engine
+ cooling and heating Systems
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Manual transmission, differential and main transfer
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Appendices


3246bbf9

Check of a condition of components of a suspension bracket and steering

Annually or each 20000 km of run

Components of a steering drive and suspension bracket should be checked regularly. The worn-out or damaged components of a suspension bracket and a steering drive can serve as the reason of excessive and dangerous wear of tires, deteriorations of running characteristics and controllability the car and to fuel consumption increase. For more detailed information on components of a suspension bracket and system of a steering address to Head the Suspension bracket and a steering.

Check of an amortization rack

 PERFORMANCE ORDER

  1. Park the car on an equal platform, switch off the engine and cock the parking brake. Check pressure in tires.
  2. Press one of car corners, then release it, paying attention to body movement. It should cease to shake and rise in a starting position after one or two musclemen.
  3. If the car continues to be shaken or did not come back to a starting position, the possible reason of it is the worn-out or weakened rack of a suspension bracket.
  4. Repeat the procedure described above for each of three remained corners of the car.
  5. To Poddomkratta the car and reliably establish it on support.
  6. Examine racks on existence of signs of leakage of hydraulic liquid. The easy film of liquid is not at the bottom for concern. In case of detection of leak make sure that liquid follows from a rack, instead of from where still. If it nevertheless leak from a rack, replace racks in pair on one axis (or all four).
  7. Check reliability of installation and integrity of racks. Check the top support of racks on existence of damages and wear signs. In case of detection of those replace racks.
  8. In case of need replacements of racks address for instructions to Head the Suspension bracket and a steering. Always replace both components on one axis, otherwise there can be a threat of safety of the car. If it is possible, try to replace all four components in a set.

Check of a condition of system of a steering and suspension bracket

 PERFORMANCE ORDER

  1. Examine components of system of a steering on existence of damages and deformations. Look for signs of leakage of the liquid, the damaged laying, protective covers and shtutserny connections.
  2. Clear the bottom end of a rotary fist. Ask the assistant to grasp bottom edge of a wheel and to shake it, and at this time watch movement of the spherical support connecting a rotary fist to the lever. Examine protective covers of spherical support on existence of gaps. If you find люфт or it is necessary to replace the torn or proceeding protective covers, a spherical support (support).
  1. Examine protective covers of spherical support on existence of gaps (are specified by an arrow).
  1. Grasp each of forward wheels for forward and back edges and try to turn it a first line inside, and back outside to check existence люфта in a steering drive. If it is found люфт, check, whether weakened fastenings of the steering mechanism and hinges of steering drafts. If weakened fastenings, tighten them. If weakened steering drafts, worn-out hinges (check at first reliability of a tightening of nuts) can be the reason. Additional information on system of a steering and a suspension bracket can be found in Head the Suspension bracket and a steering.