Nissan Primera

1990-1992 of release

Repair and car operation



Nissan Primera
+ Nissan Primera brand Cars
+ Current leaving and service
+ Engine
+ cooling and heating Systems
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Manual transmission, differential and main transfer
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   + Forward suspension bracket
   - Back suspension bracket
      Back amortization racks and shock-absorbers
      Back cross-section levers
      Back longitudinal levers
      Stabilizer of cross-section stability
      Removal of an axis of a back nave
      Back naves and bearings of naves
      Corners of installation of back wheels
   + the Steering without the hydraulic booster
   + the Steering with the hydraulic booster (servoupravleniye)
+ Body
+ Onboard electric equipment
+ Appendices


3246bbf9



Stabilizer of cross-section stability

Fastening of the stabilizer of cross-section stability on a back suspension bracket

1 — a connecting bar
2 — a nut, 42-48 N • m
3 — a bolt, 32-43 N • m
4 — an assembly collar
5 — the rubber plug
6 — a nut, 32-43 N • m
7 — an assembly bracket

8 — a bolt, 32-43 N • m
9 — a stabilizer bar
10 — an assembly bracket
11 — a bolt
12 — a bolt
13 — a nut

Removal and installation of the stabilizer of cross-section stability can be made on the basis of an illustration above. The stabilizer is fixed on fastening of an amortization rack by means of a connecting bar with two spherical fingers, and on the bottom collars and rubber plugs. To reach all fastenings, establish a back part of the car on support.

At removal watch an arrangement of rubber plugs. They have shlitsa which after installation should be turned up. Before tightening nuts of spherical hinges of a connecting bar, hinges need to be leveled at right angle to a bar. Only in this situation tighten nuts with effort of 42-48 N • m. Lower the car on the earth and tighten under loading bolts of both assembly collars.