Nissan Primera + Nissan Primera brand Cars + Current leaving and service + Engine + cooling and heating Systems + the Power supply system and production of the fulfilled gases + System of electric equipment of the engine + Manual transmission, differential and main transfer + Automatic transmission + Coupling and power shafts + Brake system - Suspension bracket and steering - Forward suspension bracket Nave of a wheel and rotary fist Forward spring and amortization rack Top cross-section lever Bottom cross-section levers Stabilizer of cross-section stability Adjustment of forward wheels + Back suspension bracket + the Steering without the hydraulic booster + the Steering with the hydraulic booster (servoupravleniye) + Body + Onboard electric equipment + Appendices
|
Stabilizer of cross-section stability
Fastening of the stabilizer of cross-section stability on the bottom party of the car. At the left a car bar with the injector engine
On a spherical support on model with the injector engine it is possible to see fastening of the stabilizer of cross-section stability on
an illustration (a position with 5 on 7). On model with the carburetor engine connection of a bar is shown on
an illustration. On an illustration other fastening of a bar of the stabilizer above is shown. At removal act as follows:
|
- Establish a forward part of the car on support.
- Weaken a connecting bar of the stabilizer according to an illustration Fastening of the top cross-section lever or Fastening of the stabilizer of cross-section stability on carburetor model.
- Unscrew both collars of the stabilizer on the left and right parties of a bar and take out the stabilizer from the forward party of a body. On an illustration fastening places in case of the established injector engine are shown. Right after removal check the stabilizer and both assembly collars. The stabilizer has color designation and assembly collars the edges should lie on one line with color lines. Assembly collars are opened on the one hand. This party should be turned to a back part of the car.
|
The stabilizer of cross-section stability is fixed on a suspension bracket in the places designated by shooters. |
- Installation is carried out in return sequence. It is necessary to observe some instructions:
- Put on assembly collars and rubber support according to the instructions provided above and screw collars. While bolts do not tighten.
- At installation of a connecting bar insert the sharovy hinge and tighten it that the finger lay at right angle to a bar. Not to warp the hinge. Tighten hinge nuts with effort of 41-51 N • m.
- At a tightening of a nut (5) (see
an illustration) or nuts (4) on
an illustration establish a wrench on a shestigrannik, approximately in the middle of a bar, as is shown in a fragment (And) (see an illustration below) that it was not turned.
|
At a tightening of nuts to hold a stabilizer bar, as is shown in a fragment "And". |
- When the car will stand again on wheels, tighten assembly collars.
|
|
|
|